subject
Physics, 26.10.2020 06:20 lai16kk77

Starting with only the Balmer series light (visible light), how could we ensure that the solar panels generate a current that Mark can use for his power station

Answers

ansver
Answer from: Quest

-first use of geothermal energy occurred more than 10,000 years ago in north america by american paleo-indians

-the first industrial use of geothermal energy began near pisa, italy in late 18th century

-in 1904, italian scientist piero ginori conti invented the first geothermal electric power plant in which steam was used to generate the power

-with the above experiment, the first geothermal plant in usa started in 1922 with a capacity of 250 kilowatts

-however, in 1946 first ground-source geothermal heat pump installed at commonwealth building in portland, oregon

-during the 1960’s, pacific gas and electric began operation of first large scale geothermal power plant in san francisco, producing 11 megawatts

-in 1973, when oil crisis began many countries began looking for renewable energy sources and by 1980’s geothermal heat pumps (ghp) started gaining popularity in order to reduce heating and cooling costs

-as effect of climate change started showing results, governments of various countries joined hands to fight against it, for which kyoto protocol was signed in japan in 1997, laid out emission targets for rich countries and required that they transfer funds and technology to developing countries, 184 countries have ratified it

hope this

ansver
Answer from: Quest
Answer sample (c); // would be best because the percentage of the energy in an incident wave that remains in a reflected wave from this material is the smallest;
ansver
Answer from: Quest
Since you have not included the experiment situation and the data, of course, i can not give you specific details about it. but i can you with this question.1) i will assume that the motion is projectile (parabolic) motion.2) yes, the horizontal distance depends on the horizontal velocity as, naming vx the horizontal velocity and t the time, it is: x = vx × t3) now, observe that the flight time depends on the vertical velocity as, naming voy the initial vertical velocity, t the time and y the vertical distance before reaching the ground: y = yo + voy×t - gt² / 2.the higher the initial vertical velocity (voy) the longer the object will be flying and so t will be higher in the equation for the horizontal distance.that explains the relationship between the horizontal distance and the horizontal velocity.
ansver
Answer from: Quest
Each student aligns the edge of the object with the left edge of the ruler as shown above. all four students read the ruler with a measurement of 4.6 cm. which statement describes the data they collect? i believe the answer is: the data have poor precision and poor accuracy because of a systematic error.

Other questions on the subject: Physics

image
Physics, 22.06.2019 04:30, phyllides4930
The current in a hair dryer measures 11 amps. the resistance of the hair dryer is 12 ohms. what is the voltage?unit:
Answers: 1
image
Physics, 22.06.2019 10:30, dontcareanyonemo
Avery long solenoid of inner radius 2.75 cm creates an oscillating magnetic field of the form = for this solenoid, =0.00425 t and =319 rad/s. (a)what is the maximum value of the induced electric field at a perpendicular distance 1.45 cm from the axis of the solenoid? (b) what is the maximum value of the inducted electric field at a point 5.85 cm perpendicular from the axis of the solenoid?
Answers: 1
image
Physics, 22.06.2019 15:30, tiffuuu
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
image
Physics, 22.06.2019 17:40, Tyrant4life
Which describes an object in projectile motion? check all that apply. a.gravity acts to pull the object downb. the object moves in a straight path. c.the forward velocity of the object is 0 m/s. d.the object’s inertia carries it forward. e.the path of the object is curved.
Answers: 2
You know the right answer?
Starting with only the Balmer series light (visible light), how could we ensure that the solar panel...