Engineering, 08.05.2022 09:40 Geo777
URGENT)Which of the following best describes the work performed by a curator?
promotion
preservation
restoration
examination
Answer from: Quest
x+2 because it just doubles hon so the pattern can actually tell you the expression.
so for example,
if x=2 then 2+2 is 4
if x=4 then 4+4 is 8
and so on and so forth.
i really hope that this makes sense and you out in a way hon: )
Answer from: Quest
answer:
science is the study of the nature and behavior of natural things and the knowledge that we obtain about them. a science is a particular branch of science such as physics, chemistry, or biology. physics is the best example of a science which has developed strong, abstract theories.
pseudoscience is a collection of beliefs or practices mistakenly regarded as being based on scientific method.
plz rate as brainliest
Answer from: Quest
What? im so confused
Answer from: Quest
answer:
dsfdssdfdssfdsfd
explanation:
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
URGENT)Which of the following best describes the work performed by a curator?
promotion
Mathematics, 29.06.2019 09:30
Biology, 29.06.2019 09:30
Mathematics, 29.06.2019 09:30
Mathematics, 29.06.2019 09:30