Engineering, 09.12.2021 14:00 jakedoc31

A six-station automatic assembly line has an ideal cycle time of 12 sec. Downtime occurs for two reasons. First, mechanical and electrical failures cause the line to stop that occur with a frequency of once per 50 cycles. The average downtime for these causes is 3 min. Second, defective components also result in downtime. The fraction defect rate for each of the six components added to the base parts at the six stations is 2%. The probability that a defective component will cause a station jam is 0.5 for all stations. Downtime per occurrence for defective parts is 2 min. Determine a) Yield of assemblies that are free of defective components? (5 marks)

b) proportion of assemblies that contain at least one defective component? (2 marks)

c) Average production rate of the good products? (10 marks)

d) Uptime efficiency? (3 marks)

Answers

Answer from: raemyiajackson1

Maybe A I’m not really sure sorry

Answer from: Quest

Am me for the answer

Answer from: Quest

import math

x=int(input("enter a number: "))

print (math.sqrt(math.fabs(

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

You know the right answer?

A six-station automatic assembly line has an ideal cycle time of 12 sec. Downtime occurs for two rea...