subject
Engineering, 30.10.2020 16:20 sarath30

You have a small 5 hp lawnmower engine that you want to adapt to pump water to an elevated storage tank. If the flow rate is to be 3 ft3 /min, what is the maximum height to which the water can be pumped? Neglect friction. [h = 881 ft]

Answers

ansver
Answer from: Quest

sorry what a asnns

explanation:

ansver
Answer from: Quest
Ireally wish i could but i will do some research and when i find the answer i will come back to assist you ; )
ansver
Answer from: Quest

answer:

when he is talking to you he wont look at you or gaf that you are alive, that is how you know

explanation:

ansver
Answer from: Quest

answer:

i need con this question too

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
You know the right answer?
You have a small 5 hp lawnmower engine that you want to adapt to pump water to an elevated storage t...