subject
Engineering, 05.06.2020 05:02 kj44

Choose the most appropriate answer in each of the following cases (with a brief justification). A: Given a channel capacity C shared by N stations that generate data at maximum rates, the CDMA-based transmission of data using M-chip code sequences allows each station to enjoy an effective transmission bandwidth share B, where: (i) B ≈ C N (ii) B ≈ C M (iii) B → C(−) (iv) B ≈ C N+M

B: IEEE 802.3 Ethernet (CSMA/CD) specifies a minimum data packet size, because: (i) Applications always generate large sized data packets (ii) Channel efficiency increases by amortizing the header overhead across a certain minimum packet size (iii) The sender of a packet should transmit long enough to hear any collisions that may occur at the farthest end of bus (iv) The application programming becomes simpler by sending a less number of large-sized packets

C: In comparison to transmission over a wired network, the signal strength over a wireless network decays rapidly with respect to the distance of receiver, because: (i) Signal energy propagates faster over wireless medium than over wired medium (ii) Signal energy propagates in all directions over wireless medium, whereas energy propagates only in the direction of wired medium; (iii) Noise signals are stronger in wireless medium that in wired medium (iv) Signal is sent on a high frequency carrier over wireless medium, whereas signal is sent as baseband over wired medium.

Answers

ansver
Answer from: Quest

answer:

yes

explanation:

ansver
Answer from: Quest

answer:

try looking it up that is always

explanation:

ansver
Answer from: Quest

answer:

no man

explanation:

no i dont want it

ansver
Answer from: Quest
Answer: i doo!
explanation:

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
image
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
image
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
image
Engineering, 04.07.2019 19:10, ultimateapes
When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?
Answers: 2
You know the right answer?
Choose the most appropriate answer in each of the following cases (with a brief justification). A:...

Questions in other subjects:

Konu
Social Studies, 10.12.2019 12:31
Konu
Computers and Technology, 10.12.2019 12:31