Computers and Technology, 13.10.2021 01:10 alundriaf6206

A selection sort algorithm for a one-dimensional array has the following steps:a) The smallest value in the array is found. b) It is swapped with the value in the first position of the array. c) The above steps are repeated for the rest of the array starting at the second position andadvancing each time. Eventually the entire array is divided into two parts: the sub-array of items already sorted which is built up from left to right and is found at the beginning, and the sub-array of items remaining to be sorted, occupying the remainder of the array. Write a C program that sorts an array of 10 integers using this algorithm.

Answers

Answer from: Quest

Answerall but the first dimension;

Answer from: Quest

I'll be your friend lol.

Answer from: Quest

You would get

Answer from: Quest

Ithink it is 1/250 i hope this is

Other questions on the subject: Computers and Technology

Computers and Technology, 21.06.2019 22:40, hePandaKing3689

State the parts of a variable declaration?

Answers: 2

continue

Computers and Technology, 22.06.2019 13:00, Cookie320

Write a program which asks you to enter a name in the form of first middle initial last. so you might enter for example samuel p. clemens. use getline to read in the string because it contains spaces. also, apparently the shift key on your keyboard doesn’t work, because you enter it all lower case. pass the string to a function which uses .find to locate the letters which need to be upper case and use toupper to convert those characters to uppercase. the revised string should then be returned to main in the form last, first mi where it will be displayed.

Answers: 1

continue

Computers and Technology, 22.06.2019 22:10, Metlife

Asequential circuit contains a register of four flip-flops. initially a binary number n (0000 ≤ n ≤ 1100) is stored in the flip-flops. after a single clock pulse is applied to the circuit, the register should contain n + 0011. in other words, the function of the sequential circuit is to add 3 to the contents of a 4-bit register. design and implement this circuit using j-k flip-flops.

Answers: 1

continue

Computers and Technology, 23.06.2019 07:00, lin550

Why were most movies from the late 1890s until the early 1930s only filmed in black and white? there were only a few people who could afford the technology to produce color motion pictures back then. audiences did not want color motion pictures until later. the film used to make color motion pictures often overheated, which was a safety hazard, so it was generally not allowed. color films had to be hand-colored, frame by frame.

Answers: 3

continue

You know the right answer?

A selection sort algorithm for a one-dimensional array has the following steps:a) The smallest value...